[57north-discuss] 3D printer

[Neil Varnas]

The printer is completely assembled and wired. All it needs is proper
configuration software wise. Unfortunately its not just plug in and play
printer, one needs to write some code and help the printer discover where
are the edges of the be, is it leveled properly and so on :) It will be max
10 lines of code but the numbers in those lines, I found a challenge of
getting them right.

-- 
Regards,
Neil V.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.57north.co/pipermail/57north-discuss/attachments/20140725/020ec792/attachment.html>